Escape Essential Oil Ultrasonic Diffuser - Physalis
DESCRIPTION
Dimensions: 71 x 71 x 140 mm
Weight (without adapter): 150 g
Power: max. 5 W
Power adapter power: DC 5V/1A.
Water tank capacity: 55 ml.
Steam output: about 18 ml/hour in continuous mode and 9 ml/hour in intermittent mode.
Recommended area: 10 to 30 m2
The device sprays a mixture of water and essential oils into millions of micro-particles in the form of a mist. Effects: it purifies the air, humidifies and gives a subtle fragrance.
The device can be used in all kinds of rooms, locker rooms, offices, hotels, hospitals, beauty salons.
The set includes:
- Ultrasonic diffuser
- USB cable
- User manual
User manual:
- Unscrew and remove the lid, pour water to the marked height
- Add max. 3 - 5 drops of essential oil
- Replace and screw on the lid
- Connect the diffuser to the power source or USB port
- One press starts the continuous mode; two presses - intermittent mode 9 s ON, 9 s OFF; and three presses - turns off the device.
Cleaning the diffuser:
Before using a new type of essential oil, clean the device
- Unplug the diffuser from the power supply and remove the lid
- Pour out the residual water from the tank
- Wipe the tank with a soft, dry cloth.
- Use a cotton swab and a few drops of alcohol to clean the ultrasonic plate
- Use a damp cloth to clean the outside of the unit
- Do not use detergents, solvents or abrasives
- Take care that water does not get into the fan
Troubleshooting:
Problem: No steam
Possible cause: Using the wrong kind of water, e.g. tap water with high mineral content.
Solution: Use distilled or purified water
Problem: No steam
Possible cause: No water in the water tank
Solution: Use distilled or purified water
Problem: No or improper steam
Possible cause: The device needs cleaning. Essential oils have stuck to the ultrasonic plate
Solution: Clean the device according to the instructions. Use clean water and clean the ultrasonic plate with a cotton swab with a few drops of alcohol
Problem: No or improper steam
Possible cause: The water level is higher than the maximum level
Solution: Clean the device and fill it halfway with water. Add more water when the unit starts producing steam. Remove excess water and restart the device
Problem: No or improper steam
Possible cause: USB cable is not properly connected
Solution: Check that the USB cable is properly connected to the power source
Problem: The device does not stop even when the water tank is empty
Possible cause: The water level indicator is dirty
Solution: Clean the device according to the instructions. In particular, make sure that the ultrasonic plate is properly cleaned
Problem: No diffusion. Unit sprays water
Possible cause: Water is too cold
Solution: Replace cold water with warm water
CAUTION
- Use only clean water at room temperature to fill the tank. Never use boiled or very cold water
- Do not move the device after filling it with water
- If you do not use the device for a long time, unplug it from the electrical outlet and pour the water out of the tank
- Never hold your hand over the ultrasonic plate when the device is on
- Never wrap the adapter in paper, plastic or other similar material, as this will prevent the adapter from dissipating heat optimally, which may eventually burn the diaphragm
- Never touch the adapter with wet hands
- Never use liquids other than water and a few drops of essential oil
- Never direct the vapor onto walls, ceiling or furniture
- Do not attempt to disassemble the device
- Never tilt, move, empty or refill the diffuser when it is on
- Do not fill the unit with more liquid than indicated
- Clean the unit regularly to prevent malfunctions
- Always place the unit on a flat, stable and hard surface
RECOMMENDED STORAGE CONDITIONS
Keep out of reach of children and pets.